What is a honed finish?

Votes: 0

Posted: 20 Feb, 2007
by: Admin A.

Updated: 20 Feb, 2007
by: Admin A.

A honed finish is used on dimensional stone panels that are sawn on six sides. It enhances the stone’s natural color and leaves a very smooth finish. It is basically a slight polish on the stone’s surface.

Others in this Category

	What are the advantages of using natural stone thin veneer over full dimensional stone?
	Is a brick ledge necessary if I want to install thin veneer on my project?
	I have ordered Palomino Granbury and the gray streak through the stone is slightly wider than the samples that I looked at. Is this normal?
	The stone that I received on my job-site looks a bit lighter in color than a project that was identified with the same material. What is the reason for this?
	Is it necessary that we seal our natural stone after we install it?
	What are the differences in cost between natural stone thin veneer and man-made stone?
	Is natural stone just a fad or is it here to stay?
	What is “split-face” material?
	I hear some people refer to the outside of some natural stone as the natural surface face and sometimes people call it rough-back. What is the difference?